EasyManuals Logo

Blue Robotics BlueROV2 Installation

Blue Robotics BlueROV2
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
5/20/2019 BlueROV2 Heavy Configuration Retrofit Kit Installation - Blue Robotics
https://www.bluerobotics.com/learn/bluerov2-heavy-configuration-retrofit-kit-installation/ 24/28
The motor directions for the BlueROV2 must be congured prior to operation.
1. Go to the *Vehicle Settings* page in QGroundControl and select the
Motors
tab in the sidebar on the left.
2. Read and understand the instructions on the setup page.
3. Arm the BlueROV2 by clicking the switch on the page.
4. One at a time, move each slider, and make sure that the motor that spins is pushing air in the correct direction. If a
motor is spinning in the wrong direction, click the corresponding checkbox under the ‘Reverse Motor Direction’
section to correct the motor rotation.
5. When you are nished with the setup, disarm the ROV by clicking the switch.
(https://www.bluerobotics.com/wp-content/uploads/2019/03/qgc-motor-setup.png?x62571)
Roll and Pitch Input
There are currently two methods available for roll and pitch input:
Be sure to keep all body parts and clothing clear of thrusters while the BlueROV2 is armed.
DO NOT run thrusters for longer than 30 seconds in air.
Privacy - Terms

Other manuals for Blue Robotics BlueROV2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Blue Robotics BlueROV2 and is the answer not in the manual?

Blue Robotics BlueROV2 Specifications

General IconGeneral
BrandBlue Robotics
ModelBlueROV2
CategoryRobotics
LanguageEnglish