15 | P a g e w w w . b l u e t i g e r u s a . c o m | 8 0 0 - 9 3 5 - 1 1 6 5
MIC BOOM TENSION
The microphone boom position tension can be adjusted. Simply tighten or loosen the mic boom by tightening or loosening
the Boom Tightening Knob (Set Screw) as shown.
1. Loosen the Headband Set Screw (counterclockwise) or tighten (clockwise) to loosen or tighten the boom position up or
down. It is not necessary to disassemble your Solare Headset. However, if the headband
were to become separated from the mic boom, simply reattach it as shown and tighten the
Set Screw. This feature allows for future accessories.
2. Reattach the Bluetooth Headset Module (mic boom) to headband and tighten the Set Screw.
IMPORTANT NOTICE: Do not remove the Solar Headband from the module. In the event that the solar
headband is removed, the Headset must be turned OFF. If solar panel is removed when the headset is ON,
it will require plugging it in to a USB Charger to power back on.
To Next Page
Loading...
