EasyManua.ls Logo

Blueridge BMY18HH22C - User Manual

Default Icon
38 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SPLIT-TYPE ROOM AIR CONDITIONER
Owner’s Manual &
Installation Manual
IMPORTANT NOTE:
Read this manual carefully before installing
or operating your new air conditioning
unit. Make sure to save this manual for
future reference.
Please check the applicable models, technical
data, F-GAS(if any) and manufacturer information
from the “Owner's Manual - Product Fiche ”
in the packaging of the outdoor unit.
(European Union products only)

Table of Contents

Questions and Answers

  • M
    Meagan TorresAug 9, 2025
    Why is my Blueridge Air Conditioner not cooling properly?
    • R
      Robert WilsonAug 9, 2025
      If your Blueridge Air Conditioner isn't cooling well, several factors could be the cause. The temperature setting might be higher than the room's ambient temperature. The heat exchanger on either the indoor or outdoor unit could be dirty, requiring cleaning. A dirty air filter can also reduce performance; remove and clean it as instructed. Obstructions blocking the air inlet or outlet should be removed after turning the unit off and then back on. Ensure doors and windows are closed to prevent heat entry, and use curtains to block excessive sunlight. Reduce the number of heat sources in the room, and check for refrigerant leaks, resealing if necessary and topping off the refrigerant. Finally, ensure the SILENCE function is deactivated.
  • D
    Diane ChapmanAug 18, 2025
    What to do if Blueridge BMY18HH22C Air Conditioner does not turn on?
    • M
      Margaret NguyenAug 18, 2025
      If your Blueridge Air Conditioner doesn't turn on, check the following: If there was a power failure, wait for the power to be restored. If the power is off, turn it on. Also, try replacing the fuse or the batteries.
  • B
    Beth StewartAug 29, 2025
    Why does my Blueridge BMY18HH22C keep turning on and off?
    • W
      William BeckerAug 29, 2025
      If your Blueridge Air Conditioner starts and stops frequently, you should check for leaks and recharge the system with refrigerant. Another solution is to evacuate and recharge the system with refrigerant. You may also need to replace the compressor or install a manostat to regulate the voltage.

Summary

Safety Precautions

Product Use Warnings

Key safety guidelines for operating the air conditioner unit.

Electrical Safety Warnings

Critical warnings regarding electrical connections and handling.

Unit Specifications and Features

Care and Maintenance

Troubleshooting

Common Issues & Solutions

Lists common problems, their causes, and solutions.

Performance & Operation Issues

Addresses performance problems and unit operation issues.

Indoor Unit Installation

Electrical Connections

Guidelines for connecting signal and power cables safely.

Outdoor Unit Installation

Cable Connections

Refrigerant Piping Connection

Pipe Connection & Torque

Air Evacuation

Evacuation Procedure

Electrical and Gas Leak Checks

Pre-Test Run Safety Checks

Test Run

Test Run Procedure

Steps for performing a 30-minute test run and checks.

Blueridge BMY18HH22C Specifications

General IconGeneral
SEER Rating22
HSPF Rating10
RefrigerantR-410A
Seasonal Energy Efficiency Ratio (SEER)22
Heating Seasonal Performance Factor (HSPF)10
Phase1
Weight (Outdoor Unit)88.2 lbs
Voltage208/230V
Cooling Capacity18000 BTU/h
Heating Capacity18000 BTU/h

Related product manuals