Ø Tighten the valve assembly side of the torch assembly above the main spreader bar assembly.
Make sure to tighten the screw to lock in the valve assembly (see figure below for details).
Ø Install the torch holder.
o Make certain the inside if the torch holder is clean and does not have any burrs. Also
make certain any tips you use are free or burrs or defect. It is important the seats are
tight.
Ø See section below on “proper lighting of gas torch”
TRANSPORTING THE MACHINE
Ø When transporting the machine, always use the carrying handles in the front and back of the
machine.
To Next Page
Loading...