Bluesky Bluetooth Headset - Disconnecting the Headset and Phone; 3 Using the Headset; Making Call; Answering Call

♦ Disconnecting the headset and Phone
When not using the headset and Phone, it can be disconnected as follows:
a. Switch off the headset.
b. Disconnect the headset or switch off the Bluetooth function in the phone.
c. Distance the headset and phone more than 10 meters apart.
3. Using the Headset
Unless stated, all Bluetooth models support the following features listed.
♦ Making Call
Dialing from the Phone: Make calls on the phone in normal ways.
Voice Dialing from the Headset: If the phone supports voice dialing, simply toggle the MFB on the
headset once. When the beep tone is heard, say the desired name (voice tag).
Redialing the Last Dialed Number: When no call in progress, hold the MFB for 2 seconds.
♦ Answering Call
To answer a call, wait for the headset ring tone, then press the MFB to accept call; or answer call via
phone in the normal way.
♦ Rejecting Call
To reject an incoming call, wait for the headset ring tone, then hold the MFB for 2 seconds.
♦ Ending Call
To end an active call, press the MFB to drop the call; or end call via phone in the normal way.
♦ Transferring Call
To transfer active call from headset to phone and vice verse, hold Vol+ for 5 seconds. May differ from
makes and models; check out the function in phone.
6
♦ Mute Call
To mute/un-mute the headset, press both the MFB and Vol+ once.
♦ Holding Call
To hold an active call, press and hold Vol- for 2 seconds. When holding call, you may answer
another incoming call or make another call from phone. To re-activate the call, press and hold
Vol- for 2 seconds.
♦ Call Waiting
To answer an incoming call during an active call, press and hold Vol- for 2 seconds. This will
put the active call on waiting; while answer the second incoming call.
♦ Call Swapping
To swap between 2 active calls, press and hold Vol- for 2 seconds.
♦ Call Conference
To have all active calls in conference, press and hold Vol+ for 2 seconds.
♦ Adjusting Headset Volume
Press the Vol+ to increase or the Vol- to decrease the volume to desire level. The headset
volume will increase/decrease in step.
♦ Low Battery Indication
When low battery level occurs, the headset beeps once every minute and Red indicator flashes
every 4 seconds.
7