Aristo Water Purifier User’s Manual
4-3. DOs and DON’Ts
Keep the water filtration system away from direct sunlight. The sun’s heat may deform
non-metallic parts and damage the electronics. It may lead to discolouration or fading of
plastic parts.
In case the unit is not used for over 4 days, shut off the source water valve and pull out the
power plug and drain the stored water completely.
Periodical filter replacement is a prerequisite for getting pure water. Depending on usage
and poor input water quality the performance of filters deteriorates. Therefore, do not
forget to get the filters replaced by Blue Star’s or its authorised dealer’s service personnel.
Do not repair, disassemble or modify any part of filtration system on your own. Fire and/or
electric shock may occur as a result. For repair, call Blue Star’s or its authorised dealer’s
service personnel.
When shifting to another house, get the unit inspected and packed by Blue Star’s or its
authorised dealer’s service personnel. This will not only keep the unit safe while shifting
but is also necessary for continuation of warranty. The packing charges will be as per
prevailing rates.
5.
C
l
e
anin
g
1.
Shut off the source water valve.
2.
Empty the water tank and pull out the power plug.
3.
Detach the cover after loosening the fixed screw on the back side of
the unit.
4.
Detach the water tank cover.
5.
Wipe the water tank with a clean soft cloth.
6.
Re-assemble the unit.
7.
Tighten the screws after inserting the cover properly.
8.
Open source water valve and connect the power plug.
9.
Drain the newly purified water completely once and then begin using it.
Notes while cleaning:
Wash your hands using sanitiser or put on sanitary gloves.
Clean the tank with soft cloth or dry cleaner.
Do not use chemicals or detergent.
Discard used cleaner, sanitary gloves, etc after cleaning.
Make sure that the tank cover is closed and filter is installed properly.
Do not pull or push the water dispensing lever with excessive force.
12 13
To Next Page
Loading...