Tie the AC300 to the grid with sub panel or plug it into the wall outlet with AC
charging cable. Then connect loads to the AC output ports of AC300.
Note: The output power in Plug-in UPS Mode is subject to the specification of the
current and voltage from home circuit.
Eg: Current (10A wire) X Voltage (240V) = 2400W in EU
12.1.2 Activiation
Go to "Settings", and then tap "Next" and "Working Mode" to select the UPS Mode.
The working mode is set at "Standard UPS" by default.
38
JUST POWER ON
To Next Page
Loading...
