• Grid Enhancement mode: By default, the Grid Enhancement mode is disabled. Please
turn it on directly in the BLUETTI app. This mode ensures that the AC60 has a stable
and continuous AC input, as it allows AC60 to adapt to voltage fluctuations and
waveform distortion of an AC source.
Note: Turn off the Grid Enhancement mode when using AC60 as a UPS. In this mode,
the UPS takes longer to switch over and may be unable to provide instant emergency
power to connected devices.
• ECO mode: When operating on ECO mode, the AC/DC output will automatically turn
off if the AC60 is bearing low or no load for a while.
When enabled, the ECO icon is displayed on the screen. Under Setting mode, press the
DC power button turn it on/off.
• Press the AC and DC power buttons at the same time to exit Setting mode.
Note: If you do not perform any operation in 1 minute, AC60 will exit Setting mode
automatically and no changes will be saved.
• Check the error code: Press the AC and DC power buttons at the same time for about 2
seconds, and then hold the AC power button to check the current error code (e.g. E001).
Output
AC output
DC output
Power
10W-30W
5W-10W
Duration
1, 2, 3, 4 hours
1, 2, 3, 4 hours
JUST POWER ON 13
To Next Page
Loading...
