Bluetti AC60 - Support and Reference; Frequently Asked Questions (FAQs)

5. Appendix
How do I know whether my devices will work well with this product?
Please evaluate the total constant load of your devices. If it doesn't exceed the Max.
output power of AC60 (600W), you can use this power station to run your devices.
Please note that if the total load exceeds the limit, but the loads on AC output is
lower than 600W, the inverter will turn off the DC output only.
Note: Some devices with built-in motor/compressor may start at 2-4 times the rated
power, which can easily overload the AC60.
Can I use third-party solar panels to charge this product?
Yes, you can. Make sure your solar panels have an open circuit voltage of 12V~28V
and have the MC4 connectors. Please do NOT mix different types of solar panels.
Note: Time required for one full charge depends on weather condition, the sunshine
intensity and the angle of solar panels.
Can it charge and discharge at the same time?
Yes. It supports pass-through charging. AC60 comes with the premium LiFePO4
battery and proprietary Battery Management System to ensure that it can charge
and discharge at the same time.
What is ECO mode and can I turn it off?
ECO mode helps save power, and you can turn it on or off on the screen. When
operating on ECO mode, the AC/DC output will automatically turn off if the AC60 is
bearing low or no load for a while. You can set the power threshold of AC output and
DC output to 10W-30W/5W-10W, respectively, for 1, 2, 3, or 4 hours.
Why is the charging power often too low?
AC60 has a built-in intelligent BMS that automatically adjusts the charging power in
response to the battery temperature and SoC, thus protecting the battery and
extending its service life.
Can I make the AC60 less noisy when charging?
Yes. Select “Silent” for AC charging in the BLUETTI app. Please refer to 4.3.1 AC
Charging for more details.
5.1 FAQs
Q1:
A:
Q3:
A:
Q2:
A:
Q4:
A:
Q5:
A:
Q6:
A:
JUST POWER ON 19