Bluetti B210P - Troubleshooting

10. Troubleshooting
In case of a B210P failure, the Power Button or DC Power Button light will flash. If the
latter flashes, press and hold it for about 3 seconds, and the SoC indicator will start
flashing. Please refer to the table below for helpful guidance.
Flashing Indicator Description
BMS failure
PV input overvoltage or
charging temperature
too high
DC output overload
Power off the B210P, and disconnect
all electrical connections.
Ensure that PV input voltage is
within the range of 11VDC to 60VDC;
when the temperature is too high,
wait for it to cool down before
charging.
Check if the power consumption of
your devices is too high.
Reduce the load if necessary.
Power Button Light
Second SoC Indicator
Third SoC Indicator
Troubleshooting
DC output overcurrent
Operating temperature
too high or too low
/
Check if the power consumption of
your devices is too high.
Reduce the load if necessary.
Recommended charging temperature:
0°C to 40°C / 32°F to 104°F
Recommended discharging temperature:
-20°C to 40°C / -4°F to 104°F
Please contact BLUETTI support
for assistance.
Fourth SoC Indicator
Fifth SoC Indicator
Others
JUST POWER ON 19
EN