13 | P a g e
In this position, the BLH will produce chlorine according to the “Desired Level %”
adjustment setting for the entire filtering / pumping cycle.
• SUPER CHLORINATE: When you have an abnormally high bather load, heavy
rainfall, cloudy water conditions, or any other condition which requires that a large
amount of purification be introduced, set the Main Switch in the SUPER
CHLORINATE position. This electronically “super chlorinates” (shocks) the water
for 24 hours (filter pump must be on during this time) or until the power has been
turned off, whichever comes first. At the end of the super chlorination period, be
sure to put the switch back into the AUTO position.
• OFF: The OFF position, prevents the BLH from energizing the electrolytic cell. In
this position there is no chlorine generation.
NOTE: In times of servicing, the OFF switch is not to be used. To service the BLH, turn the
power off the circuit breaker.
DESIRED OUTPUT LEVEL CONTROL
This setting is used to control the amount of chlorine the BLH generates. Adjust this setting
to increase or decrease the chlorine output level percentage. The reading is from 5 % output
to 100% output capacity of the BLH.
INDICATOR LED
• POWER: When illuminated solid, the BLH has input power.
• GENERATING: This LED is illuminated solid during normal operation. When
flashing, the pool water is too hot or cold to operate.
• SUPER CHLORINATE: Illuminates solid during Super Chlorination. See
description above for more information.
• REMOTE CONTROLLED: This part is controlled by a remote-control system.
• NO FLOW: When illuminated, the flow switch has detected no flow and the BLH
is NOT generating chlorine. A flashing LED indicates that the flow has been
To Next Page
Loading...