14 | P a g e
restored, but there will be a 60-second delay before the generation is reestablished.
• CHECK SALT: When flashing, the salt level is low (below 2500ppm) and the BLH
is generating at low efficiency. When illuminated solid, the salt level is too low and
the BLH has shut down.
Note: Before adding large quantities of salt, it is advisable to have your salt level
professionally checked.
• HIGH SALT: When illuminated, the salt level is too high and the BLH has shut
down. The pool water must be diluted with fresh water before the system operation
is restored.
• INSPECT CELL: If flashing, either the cell efficiency is reduced, or it is time for
regularly scheduled cell inspection. In either case, inspect the cell and clean it if
necessary. Pressing the “diagnostic” button next to the display for 3 seconds will
stop the flashing LED. When illuminated steady, cell efficiency is greatly reduced
and the BLH has stopped producing chlorine. Inspect, clean or replace if
necessary.
SALT DISPLAY
The Salt Display shows the current salt concentration of the pool water. Readings are in ppm
(parts per million). If Metric units (grams per liter) are preferred, push the “diagnostic” button
next to the display once. The display will now show the pool water temperature in degrees
Fahrenheit. With the temperature displayed, move the main switch from AUTO to SUPER
CHLORINATE to AUTO. The temperature display will instantly change to degrees Celsius.
Repeat this process to switch back to USA units (Fahrenheit).
Diagnostic Displays
Sequential pushes of the small "diagnostic" button next to the LCD-display will
cause the system display the following information:
1. Pool temperature (xx degrees Fahrenheit or Celsius)
To Next Page
Loading...