15 | P a g e
2. Cell voltage (typically 21.0 to 27.0 volts when chlorine is being generated, otherwise 16-
25V)
3. Cell current (typically 2.50 to 7.80 amps when chlorine is being generated, otherwise 0
amps)
4. Desired Output % ("0%" -- "100%" depending on knob position or input from remote pool
automation controller)
5. Instant salinity (-XXXX ppm) or (-X.XX grams/Liter)
6. Product name sent to the pool automation control display
7. Software revision level
8. Cell type.
On the 8th push of the button, the display will revert to the original default salt display. Also,
if the button is not pushed for 30 seconds, the display will revert to the original default salt
display.
OPERATION
By familiarizing yourself with the operation of the BLH generator, you can achieve maximum
performance for your pool. When chemical levels are in the recommended range, there are
FOUR factors that you can control. These factors will directly impact the amount of chlorine
the BLH will generate.
• Filter time each day (hours)
• The amount of salt in the pool
• The “Desired Output Level %” setting
• Stabilizer level in the water.
To find the optimum “Desired Level %” setting, start at a high setting and work downward. It will
take a few days of adjustments to find the ideal setting for your pool. Once determined, it should
only take minor adjustments to maintain the ideal setting. The BLH control will not produce chlorine
at temperatures below 50’F If your pool water is colder than 50’F, you must chlorinate manually.
Maintaining the System
To maintain maximum performance, it is recommended that you remove and visually inspect
the cell every 3 months. The BLH will remind you to do this by flashing the “Inspect Cell” LED
To Next Page
Loading...