BLUM IC56

Mountingandcommissioning
V2A|04/2018
10
©byBlum‐Novotest
3. Mountingandcommissioning
CAUTION!
Physicalinjuriesandmaterialdamagesofthecomponentscausedbyvoltage
 Makesurethatthecomponentsarevolt‐freeduringinstallationwork.
NOTICE
Damagesofthemeasuringsystembychipsarepossible.
 Neverinstallcablesandwireswithoutprotectionintheworkingarea.
 Protectcablesandwiresintheworkingareaagainstflyingchips,e.g.byprotectionhose,
protectionspring,cover,etc.
NOTICE
Damagetothemeasuringsystembysharpedgespossible.
 Pleasedeburrthesharpedgesonthecablebushingandmountedgeprotection.
NOTICE
Damagebyimproperinstallationofcablesandhoses
 Whenmountingcablesandhoses,pleaseprovidesufficientstrainrelief.
 Pleasenotetheminimumbindingradiusofcablesandhoses.
NOTICE
Damagescausedbyimproperinstallation/dismounting
 Pleaseonlyuseoriginalreplacementpartsaswellastheprovidedspecialtools.
 Considerthemaximumtighteningtorque.
3.1 Mountingposition
Chooseamountingposition,inwhichothermachinesarenotaffected.Testthe
mountingpositionbeforethefinalmounting.
Thereceivershouldbeplacedprotectedfromcoolantandchips.
Distancebetweenprobeandreceiver:Payattentiontochap.2.5.
Aligntheopticsofthereceivertotheprobeinmeasuringposition.