BLUM SERVO-DRIVE Problem Resolution

2
Problem Possible cause Remedy
1.1 Pull-out will not open. Cabinet profile is positioned
incorrectly.
➢ Correct installation position of
cabinet profile.
Pull-out is blocked by an
object.
➢ Remove object
Bracket profile and/or attach-
ment bracket is positioned
incorrectly.
➢ Correct position of bracket profile
and/or attachment bracket.
1.2 Pull-out will not open.
There is no 2 mm
bumper path.
No Blum spacing bumper is
installed.
➢ Front height is smaller than
300 mm: Install 1 Blum spacing
bumpers per side.
➢ Front height is larger than
300 mm: Install 2 Blum spacing
bumpers per side.
No Blum spacing bumper is
installed. (inner drawers or
drawers with inset fronts)
➢ Make sure that the correct Blum
distance bumper has been used
(adjustable distance bumper).
Fronts are rubbing against
each other.
➢ Reset gap design.
Slide-on technology:
Locking device height adjustment
Slide-on and clip-on feature:
Front tilt adjustment
Clip-on feature:
Height adjustment for full exten-
sion
Clip-on feature:
Height adjustment for single
extension
Cabinet profile is positioned
incorrectly.
➢ Correct installation position of
cabinet profile.
Bracket profile and/or attach-
ment bracket is positioned
incorrectly.
➢ Correct position of bracket profile
and/or attachment bracket.
Pull-out is blocked by an
object.
➢ Remove object.
Problem resolution
We recommend the following troubleshooting sequence.
1
2

BLUM SERVO-DRIVE Specifications

General

Brand	BLUM
Model	SERVO-DRIVE
Category	Servo Drives
Language	English