BLUM Aventos HK-S User Manual

AVENTOS HK-S
Subject to technical modifications without notice. © 2015
1
Lift mechanism set
Set includes:
▀
Lift mechanism (qty 2)
▀
Cover plate (left and right)
Also includes:
▀
SCHR 4X35 — #7 x 35 mm (1-3/8”)
wood screw (qty 10)
Power factor Opening angle Part no.
19 — 39 107°
20K2B00.N1
40 — 85 107°
20K2C00.N1
86 — 177 107°
20K2E00.N1
Wood or wide aluminum door mounting plate
▀
W o o d o r w i d e a l u m i n u m m o u n t i n g p l a t e ( q t y 2 )
Part no.
Wood or wide aluminum mounting plate
175H3100
Installation screw for wood doors
606N or 606P
Installation screw for wide alum doors
7072A
Narrow aluminum door mounting plate
▀
N a r r o w a l umi n u m m ou n t in g p late (q t y 2)
(for use with AVENTOS HK-S only)
▀
Includes 699.1100 installation screws (qty 4)
Part no.
Narrow aluminum mounting plate
20K4A00A02
Recommended parts for tension adjustment
Use of a POZI bit insert and bit holder is recommended when adjusting the tension of the
lift mechanism.
Part no.
#2 x 2" POZI bit insert
POZI BIT #2x2
1/4" bit holder
BIT HOLDER
Required parts
Assembly instructions

BLUM Aventos HK-S Specifications

General

Opening Angle	107°
Power Factor Range	Not applicable
Type	Lift System
Application	Wall cabinets
Adjustment	3-dimensional adjustment
Material	Steel
Color	Light gray (RAL 9006)

Summary

Required Parts for AVENTOS HK-S

Lift Mechanism Set Details

Specifies lift mechanisms, cover plates, and screws included in the set.

Mounting Plates for Doors

Lists mounting plates and screws for wood/wide aluminum and narrow aluminum doors.

Tension Adjustment Tools

Recommends POZI bit insert and bit holder for adjusting lift mechanism tension.

AVENTOS HK-S Assembly Instructions

Locating Pins and Minimum Depth

Guides on positioning locator pins and determining minimum depth for cabinets.

Attaching the Lift Mechanism

Instructions for aligning and securing the lift mechanism to the cabinet.

Mounting Plate Installation

Details for attaching mounting plates to wood/wide aluminum and narrow aluminum frames.

Raising the Lever Arm Assembly

Procedure for safely raising the lever arm and removing a plastic tab.

Attaching the Door to Mechanism

Steps for connecting the door to the lift mechanism using the CLIP system.

Adjusting Door Tension

How to use tools to adjust the tension of the lift mechanism for the door.

Finalizing Door Adjustments

Guides on performing three-dimensional adjustments using a POZI screwdriver.

Attaching Cover Caps

Instructions for snapping the left and right cover plates onto the lift mechanisms.

AVENTOS HK-S Removal Instructions

Removing the Door from Mechanism

Steps to detach the door by disengaging the CLIP mechanism.

Removing Cover Plates

Procedure for removing the cover plates from the lift mechanism.

Technical Specifications and Clearance

Panel and Face Frame Clearance Data

Provides clearance measurements for panels and face frames and door thickness conversions.