K Setting needle
B-1 Internal handle
cover
B-2 Battery cassette
B-Internal handle
A-External
handle
H-Connection
sleeve
I-Snap off screw
G Hollow spindle
Installation Using Through Fixings
P-11
04
01
02
03
08
09
a
a
Open the door and put something in the doorway to ensure the door doesn't close throughout
installation.
Check the condition of the existing latch, ensure that it retracts fully when the handle is fully
pushed down. If it doesn't, you may need to replace the latch before fitting the Breeze handle.
Remove the existing handles. For handles with exposed screws, remove the fixing screws. For
rectangular backplate handles with hidden screws, carefully take off the outer cover plate to reveal
the fixing screws. For circular backplate handles with hidden screws, you may need to twist the
outer cover to remove it and reveal the screws. If the handle doesn't easily remove, check there is
no grub screw in the back of the handle grip. If there is, remove the grub screw, then remove the
handles and spindle.
You can either fit this handle with 4 self-tapping screws (J) (this is simpler and requires no drilling),
or with through fixings (H,I) (this requires drilling but is more secure). If you choose to use
self-tapping screws, skip to Step 7.
Locate the hollow Breeze spindle (G) and the paper fitting template. Follow the instructions on the
template to ensure it lines up correctly. You can then use the template to mark the door with a
pen/pencil where holes need to be drilled. Do this on both sides of the door.
You will need an 10mm drill bit. Take your drill, make sure it is level and drill a hole through the door
at the marked positions. Check the other side of the door, if it was level, you won't see the marks
you made for holes.
You can check this was done correctly by putting the template back over the latch. The drilled holes
should match the template. If they don't, your drill may not have been level. Use your drill to make
these holes level.
If you haven’t already, please make sure the handles open in the correct direction. If they don’t, go
back and follow the ‘Change the handle direction’ instructions to make sure they open correctly
before moving to the next step.
Using the external handle (A), take the spindle (G) and feed the wire through the hollow opening,
then push the spindle into the handle.
If using the through fixings (H,I), take the connection sleeves (H) and push them into the holes at
the top and bottom of the external handle.
Feed the wire and spindle through the latch in the door. The handle should push flat against the
door.
Through fixings (H,I) - The connection sleeves should line up with the holes you previously drilled.
05
06
07
a
Model C Installation
F Key
To Next Page
Loading...