Blusens H305
31
ENGLISH
Sharpness: Adjust the sharpness of whole picture; increasing
analog value increases definition, decreasing analog value decreases
definition (0-100).
Tint: Adjust the tint of whole picture; increasing analog value
increases green, decreasing analog value increases purple (0-100).
NOTE: Tint can be adjusted only in NTSC system.
After selecting Color Temperature, press OK key to enter into Color
Temperature submenu. Press / key to select item you´d like to adjust
or set.
Color Temperature: Select color temperature between four modes:
Standard, Warm, User and Cool.
Red: Adjust red; increasing analog value increases red, decreasing
analog value decreases red (0-100).
Green: Adjust green; increasing analog value increases green,
decreasing analog value decreases green (0-100).
Blue: Adjust blue; increasing analog value increases blue, decreasing
analog value decreases blue (0-100).
NOTE: The adjustment on red, green and blue is only available under User
states.
After selecting Noise Reduction, press OK key to enter into Noise Reduction
submenu. Press / key to select Noise Reduction mode: Off, Low, Middle,
High and Default.
To Next Page
Loading...