BluStream Custom Pro Matrix Series - Page 29

29
contact support@blustream.co.uk | support@blustream.com.au
CUSTOM PRO MATRIX USER MANUAL
RS-232 and Telnet Commands
COMMAND ACTION
?
Print help information
HELP
Print help information
STATUS
Print system status and port status
PON
Power On, system run on normal state
POFF
Power O, system run on power save state
IR ON/OFF
Set system IR control On or O
KEY ON/OFF
Set system (front panel) KEY control On or O
BEEP ON/OFF
Set onboard beep On or O
LCD ON/OFF
Set LCD always On or Auto turn o in power on
state
RSB x
Set baud rate to x bps
x = 0: 115200
x = 1: 57600
x = 2: 38400
x = 3: 19200
x = 4: 9600
RESET
RESET ALL
Reset system to default setting
Reset system and network to default setting
(type “Yes” to confirm, “No” to Discard)
IN CSC ON/OFF
Set all Input ports CSC mode On or O
OUT CSC ON/OFF
Set all Output ports CSC mode On or O
IN xx UHD ON/OFF
Set INPUT:xx EDID support UHD mode On or O
xx=[00]: ALL Input port, [01...16]: Input port
AUD STA
Print Input/Output port audio setting state
AUD RX xx ORG
Input port:xx use original receive HDMI/DVI signal
AUD RX xx ANA
Input port:xx insert stereo to HDMI/DVI signal
AUD RX xx AUTO
Input port:xx insert stereo to DVI signal only
xx==[00]: All Input Port, [01...08]: Input Port
COMMAND ACTION
VOL xx TX yy
Set output audio:yy volume to:xx
yy=[00]: All output audio, [01..16]: Output audio
xx=[00..100]: volume value
xx=+: Volume increase
xx=-: Volume decrease
MUTE ON/OFF
TX yy
Set output audio:yy Mute On or O
yy=[01..16]: Output audio
OUT xx ON/OFF
Set OUTPUT:xx On or O
POH TX xx ON/OFF
Output xx turn ON/OFF POH (Keeps Zone active
but cuts PoC for when output is connected to
third party HDBaseT hardware
OUT xx FR yy
Set OUTPUT:xx from INPUT:yy
OUT xx EH/ET
Set OUTPUT:xx use HDMI/HDBT EDID
xx=[00]: All OUTPUT port, [01...08]: OUTPUT port
yy=[01...08]: INPUT port
MUTE ON/OFF
OUT yy
Set output audio: yy mute ON or OFF
NET DHCP ON/OF
Set auto IP (DHCP) ON or OFF
NET IP xxx.xxx.
xxx.xxx
Set IP address
NET GW xxx.xxx.
xxx.xxx
Set gateway address
NET SM xxx.xxx.
xxx.xxx
Set subnet mask address
NET RB
Set network reboot and apply new config
NET TN xxxx
Set telnet port
PRESET STATUS
Print present config status
PRESET pp SET aa,
bb, cc ... oo, pp
Set preset config
pp=[01..08]: select preset index
aa=[01..16]: output 01 from aa, [00]: not set
bb: output 02 ... pp: output 16
PRESET pp SAVE
Save current output connection to preset:pp
config
PRESET pp APPLY
Apply preset:pp config to output connection