BluStream Custom Pro Matrix Series - Page 4

04
www.blustream.co.uk | www.blustream.com.au
CUSTOM PRO MATRIX USER MANUAL
Rear Panel
Front Panel
Panel Descriptions - 8x8 Chassis
1
8 9 q w e
2 3 4 5 6 7
1 TCP/IP port - for control of the matrix from PC or third
party control processor
2 RS-232 / serial connector - for control of the matrix (as
above)
3 Analogue L/R line level input (3.5mm stereo jack)
audio can be embedded onto video inputs
4 RS-232 control card slots - insert optional RS-232
control cards for serial control at HDBaseT™ receivers
5 Audio output card slot - insert optional audio card for
zone / output audio breakout
6 IR control card slot - insert optional IR control card for
2-way & Global IR control
7 Mains power switch
8 Video input card 1 (inputs 1-4) - insert video input
card to connect to source devices (mandatory)
9 Video input card 2 (inputs 5-8) - insert video input
card to connect to source devices (optional)
q Video output card 1 (outputs 1-4) - insert video output
card (mandatory)
w Video output card 2 (outputs 5-8) - insert video output
card (optional)
e Power port – use supplied 24V 8A DC adaptor to
power matrix
1 LCD display - shows the status of input / output
selection, EDID etc.
2 IR receiver window
3 Input / output selection buttons - select output
number first followed by the input to be viewed
4 Up / Down / Le / Right selection buttons - for use
when navigating through matrix menu
5 Menu button - press to enter menu structure - see
page 15 for more details
6 Power button - press and hold for 2 seconds to power
o
7 Exit / Cancel button - return to last menu page / exit
to main display page
8 Enter / Confirm button
1
2
3 4
5 6
78