BluStream Custom Pro Matrix Series - Page 5

05
contact support@blustream.co.uk | support@blustream.com.au
CUSTOM PRO MATRIX USER MANUAL
Front Panel - touch panel shown only for illustrative purposes
Panel Descriptions - 16x16 Chassis
Rear Panel
1 LCD display - shows the status of input / output
selection, EDID etc.
2 IR receiver window
3 Input / output selection buttons - select output
number first (up to 2 digits), followed by enter, then
input number
4 Up / Down / Le / Right selection buttons
5 Menu button -press to enter menu structure - see
page 15 for more details
6 Power button - press and hold for 2 seconds to power
o
7 Exit / Cancel button- return to last menu page / exit to
main display page
8 Enter / Confirm button
1 TCP/IP port - for control of the Matrix from PC or third
party control processor
2 RS-232 / serial connector - for control of the matrix (as
above)
3 Analogue L/R line level inputs (3.5mm stereo jack)
Audio can be embedded onto video outputs
4 RS-232 control card slots - insert optional RS-232
control cards for serial control at HDBaseT™ receivers
5 Audio output card slots - insert optional audio cards
for zone / output audio breakout
6 IR control card slots - IR control card for 2-way &
Global IR control (supplied within 16x16 chassis)
7 Mains power switch
8 Video input card slots 1-4 (inputs 1-16) - insert video
input cards to connect to source devices (input card
slot 1 mandatory; 2-4 optional)
9 Video output card slots 1-4 (outputs 1-16) - insert
video output cards (output card slot 1 mandatory; 2-4
optional)
q Power port – use supplied IEC cable to power matrix
1 2 3 4 5 6
7
8 9 q
1 2 3 4 5 6
78