BluStream MX42AB - Rear Panel and Connectivity; Rear Panel Ports; Control and Configuration; Remote Control Operations

MX42AB USER MANUAL
04
contact
Rear Panel
4
1 IR inputs 1 – Zone specific
3.5mm stereo jack IR inputs
Blustream 5v IR receivers/cables
must be used.
Please use Blustream 5v emitters
t
r
rz
2 - e c rtIR outputs 1 o 4 – Sou e sp
cific 3.5mm IR jacks which p ovide
rou ed IR f om the one IR inputs.
Routing is determined by which
source is selected in a zone.
4 Coaxial output – RCA (S/PDIF) audio
output extracted from HDMI output
(Zone specific)
5 L/R output – 3.5mm stereo Audio
jack, audio extracted from HDMI
output (Only supports stereo PCM
digital audio feeds)
6 Power switcher – Press to power
7 HDMI inputs 1 to 4 – Connect HDMI
sources
8 HDMI outputs 1 – Output for
displays, AVR etc.
9 RS232 female port – RS232 connec-
tion enabling external third party
setup and control of the matrix.
q Power port – Use included
DC adaptor to power the matrix
switcher.
Remote Control Description
OUTPUT AND INPUT SELECTION
A Selects the zone OUTPUT you wish to
change the source on (Numbers 1 - 2
correspond to the zone outputs 1 - 2)
B Selects the source INPUT you wish to
change on the selected zone
(Numbers 1 - 4 correspond to the
source inputs 1 - 4)
EXAMPLE
To switch source 2 to zone 1 you would
press 1 in the output section (A) followed
by pressing 2 in the Input section (B).
ALL button: The all button selects all the
inputs or outputs in its corresponding box.
Example: (The “All” button in the Output
box selects all the zones so all zones will
change to what source input is selected
next)
PTP: This button will align all the zone
outputs with the like numbered source
inputs. Example: Input 1 to output 1, input
2 to output 2, etc
EDID SET UP
The MX42AB provides a comprehensive
range of EDID settings. Below are three ex-
amples of how to deploy the desired EDID
setting when using the supplied remote.
A. Fix EDID to an INPUT or ALL inpus:
Press the desired video resolution
button (1080I / 1080P / 3D / 4K),
then select the desired audio format
(2.0CH / 5.1CH / 7.1CH), then select
the source input you want this EDID
information allocated to by pressing
the INPUT 1 – 4 or the ALL button
B. Copy EDID of OUTPUT-X to an
INPUT or ALL: Press the COPY but-
ton then select the OUTPUT you wish
to copy the EDID information from,
then select the source input you want
to copy this EDID to by selecting the
INPUT 1-4 or the ALL button.
C. User defined EDID to an INPUT or
ALL inputs: Press USER1 / USER2
button then select the source you
wish to assign this EDID to by select-
ing INPUT 1-4 or the ALL button
NOTE: The button press sequence should
be finished in 5 seconds, otherwise the
operation is discarded.
A
B
EDID
MX42AB
3
10
7 8 9
1 2 4 45 5 6
r
t
rt
3 IR extension receiver input –
3.5mm s e eo Audio jack enabling
the use of an ex ernal IR sensor for
cont ol of the matrix.