7. Add grease on the RAD seatpost.
8. Pull now the cable making sure the cable
housing end is correctly positioned
against the RAD seatpost.
9. Install the cable on the remote lever and
tighten the pinch bolt according to the
torque settings indicated on the lever
itself. Cut now the cable.
10. Insert the RAD seatpost in the seattube.
Make sure the seatpost is in the correct
position: the seatclamp screw is on the
right side of the sleeve.
11. Push the seatpost in the seattube until
the seatclamp screw is visible through
the opening.
18
To Next Page
Loading...
