EasyManuals Logo

BMW Motorrad R nineT/5 User Manual

BMW Motorrad R nineT/5
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
WARNING
Tendency of valve inserts to
open by themselves at high
riding speeds
Sudden loss of tyre pressure
Install valve caps fitted with
rubber sealing rings and tighten
firmly.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Check tyre pressures against
the data below.
Tyre pressure, front
2.5 bar (One-up and two-up
with luggage, tyre cold)
Tyre pressure, rear
2.7 bar (One-up, tyre cold)
Tyre pressure, rear
2.9 bar (Two-up mode with
load, with cold tyres)
If tyre pressure is too low:
Correct tyre pressure.
Rims and tyres
Checking rims
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Visually inspect the rims for
defects.
Have damaged rims checked
and, if necessary, replaced by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
Checking spokes
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Draw the handle of a screw-
driver or a similar instrument
across the spokes and listen to
the sequence of sounds made
by the individual spokes.
If there is a variation in the se-
quence of sounds:
Have the spokes checked by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
Checking tyre tread depth
WARNING
Riding with badly worn tyres
Risk of accident due to impaired
handling
If applicable, have the tyres
changed in good time before
they wear to the minimum
tread depth permitted by law.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
8
92
z
Maintenance

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BMW Motorrad R nineT/5 and is the answer not in the manual?

BMW Motorrad R nineT/5 Specifications

General IconGeneral
Displacement1170 cc
Transmission6-speed
Seat Height805 mm
Compression Ratio12.0:1
Final DriveShaft drive
Front Wheel Travel120 mm
Rear Wheel Travel120 mm
ABSStandard
Front Tyre120/70 ZR17
Rear Tyre180/55 ZR17
Bore x Stroke101 mm x 73 mm
Fuel SystemElectronic fuel injection
Front Suspension Diameter43 mm
Engine TypeAir/oil-cooled flat twin
Power80 kW (109 hp)
Torque116 Nm
Fuel Tank Capacity17 l (4.5 gal)
Engine DetailsAir/oil-cooled flat twin (boxer), four-stroke
Fuel ControlElectronic intake pipe injection
Emission ControlClosed-loop 3-way catalytic converter, emission standard EU-4
FrameSteel tubular frame
Front SuspensionTelescopic fork
Rear SuspensionSwingarm
Front BrakeDouble disc
Rear BrakeSingle disc
DIN unladen weight, ready for road221 kg
Frame TypeSteel tubular frame

Related product manuals