NOTE
Automatic Hold applies the parking brake when
the vehicle is stationary and prevents the vehi‐
cle from rolling in car washes. There is a risk of
material damage. Deactivate Automatic Hold
before driving into the car wash.
Overview
Automatic Hold
Activating the Automatic Hold
function
1.
Switch on drive-ready state.
2.
Press the button.
The LED is illuminated.
The indicator lamp illuminates green.
Automatic Hold is ready to operate.
When the vehicle is restarted, the last se‐
lected setting is retained.
Automatic Hold holds the vehicle
Operational readiness is established and the
driver's door is closed.
Once the brake has been applied, the ve‐
hicle is secured from rolling as soon as
the indicator lamp is illuminated green.
Driving off
To drive off, press the accelerator pedal.
The brake is released automatically and the indi‐
cator lamp for the parking brake is no longer illu‐
minated.
Automatic activation of the parking
brake
The parking brake is automatically applied when
the vehicle is being held by Automatic Hold and
drive-ready state is switched off or the vehicle is
exited.
The indicator lamp changes from green
to red.
The parking brake is not applied automatically if
drive-ready state was switched off while the ve‐
hicle was still rolling. Automatic Hold is switched
off in this case.
Switching off operational readiness
Press the button.
The LED is extinguished.
The indicator lamp extinguishes.
Automatic Hold is switched off.
If the vehicle is being held stationary by Auto‐
matic Hold, also depress the brake pedal when
switching off.
Malfunction
If the parking brake has failed or malfunctioned,
secure the vehicle to prevent it from rolling away
before leaving the vehicle.
A Check Control message is shown.
After getting out, secure the vehicle to prevent it
from rolling away, for example with a chock.
Seite 160
CONTROLS
Driving
160
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
