After a power failure
To restore parking brake functionality after a
power failure:
1. Switch on standby state.
2.
Pull the switch with the brakes applied
or selector lever position P engaged and then
press it.
The procedure can take a few seconds. Any
sounds that occur are normal.
The indicator lamp no longer illuminates
as soon as the parking brake is once
again operational.
Turn indicator
Turn indicator in exterior mirror
Do not fold in the exterior mirrors while driving or
while operating the turn indicators or hazard
warning lights to ensure that the indicator lamps
in the exterior mirrors are well recognisable.
Indicating
Press the lever beyond the resistance point.
Triple turn signal
Briefly press the lever up or down.
The duration of the triple turn signal can be set.
1.
"CAR"
2. "Settings"
3. "Exterior lighting"
4. "One-touch indicator"
5. Select the desired setting.
The setting is saved for the current driver profile.
Indicating a turn briefly
Press the lever as far as the resistance point and
hold it there for as long as you wish to indicate a
turn.
High-beam headlights,
headlight flasher
Push the lever forwards or pull it back.
▷ High-beam headlights on, arrow 1.
The high-beam headlights are illuminated
when the low-beam headlights are switched
on.
▷ High-beam headlights off/headlight flasher,
arrow 2.
Wiper system
General
Do not use the wipers on a dry windscreen, oth‐
erwise the wiper blades will wear or become
damaged more quickly.
Seite 161
Driving
CONTROLS
161
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
