Rear wiper
Overview
Switching on
Turn the outer switch upwards.
▷ Rest position of the wiper, position 0.
▷ Intermittent mode, arrow 1. Engaging reverse
gear activates continuous operation.
To clean the rear window
Turn the outer switch in the desired direction.
▷ In rest position: turn the switch downwards,
arrow 3. The switch returns to the rest posi‐
tion when released.
▷ In intermittent operation: turn the switch fur‐
ther, arrow 2. The switch returns to the inter‐
mittent position when released.
The function is deactivated if the washer fluid
level in the reservoir is low.
Fold-out position of the wipers
Principle
In the fold-out position, the wipers can be folded
away from the windscreen.
General
This is necessary for example when replacing the
wiper blades or to keep them away from the
windscreen when there is frost.
Safety notes
WARNING
If the wipers start moving when they are folded
away from the windscreen, parts of the body
may become trapped or the vehicle may be
damaged. There is a risk of injury or material
damage. Make sure that the vehicle is switched
off when the wipers are folded away from the
windscreen, and that the wipers are in contact
with the windscreen when switching on.
NOTE
If the wipers are frozen to the windscreen,
switching them on may cause the wiper blades
to tear off and the wiper motor to overheat.
There is a risk of material damage. Defrost the
windscreen before switching on the wipers.
Folding out the wipers
1.
Switch on standby state.
2. Press the wiper lever down and hold until the
wipers stop in an approximately vertical posi‐
tion.
Seite 164
CONTROLS
Driving
164
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
