BMW 320e - Page 257

Button Function
Without steering and lane control as‐
sistant:
To resume Cruise Control with last
setting.
Without steering and lane control as‐
sistant:
To interrupt Cruise Control.
Increase the distance.
Switch distance control on/off.
Reduce the distance.
Switch distance control on/off.
Rocker switch:
Set the speed.
Sensors
The system is controlled using the following sen‐
sors:
▷ Cameras behind the windscreen.
▷ Front radar sensor.
For further information:
Sensors of the vehicle, see page 47.
Use
The system can be used to optimum effect on
well-constructed roads.
The minimum speed that can be set is
30 km/h/20 mph.
The maximum speed which can be set is limited
and depends on the vehicle and its equipment,
for example.
After toggling the Cruise Control without dis‐
tance control, even higher desired speeds can
be selected when driving with the internal com‐
bustion engine.
The system can also be activated when the vehi‐
cle is at a standstill.
Switching Cruise Control on/off
and interrupting
With steering and lane control
assistant: Assisted Driving Mode
General
The button is used to switch the set
function on and off.
The button is used to set the primary
function.
Setting the function
When the system is active, press the
button until the desired function is se‐
lected in the toolbar. The Assisted Driving Mode
function bar is shown at the bottom of the instru‐
ment cluster.
Symbol Function
Cruise control with distance control.
Depending on equipment, cruise
control with distance control and
steering and lane control assistant.
The selected function is shown in green.
The setting is saved for the current driver profile.
Switching on
With steering and lane control assistant:
1. Press the button on the steering
wheel.
2.
Set Cruise Control if necessary.
Without steering and lane control assistant:
Seite 257
Driver Assistance Systems
CONTROLS
257
Online Edition for Part no. 01405A1EA53 - X/20