Without Surround View:
rear-view camera
Principle
The rear-view camera provides assistance when
reverse parking or manoeuvring. It does this by
showing an image of the area behind the vehicle
on the Control Display.
Assistance functions, for example auxiliary lines,
can also be shown on the display.
Safety note
WARNING
The system does not relieve you of your per‐
sonal responsibility to assess the traffic situa‐
tion correctly. There is a risk of accident. Adapt
your driving style to the traffic conditions. Addi‐
tionally, look directly to check the traffic situa‐
tion and the area around the vehicle and inter‐
vene actively where appropriate.
Overview
Depending on the equipment:
button in the vehicle
Park Assistant button
Sensors
The system is controlled using the following sen‐
sors:
▷ Rear-view camera.
For further information:
Sensors of the vehicle, see page 47.
Switching on/off
Automatic activation
The system automatically switches on when se‐
lector lever position R is engaged while the en‐
gine is running.
Automatic deactivation when
moving forwards
The system switches off once a certain distance
or speed is exceeded.
Switch the system back on if necessary.
Depending on the equipment:
switching on/off manually
Press the Park Assistant button.
▷ On: the LED is illuminated.
▷ Off: the LED is extinguished.
The parking assistance functions are shown on
the Control Display.
Switching the view via iDrive
If the rear-view camera view is not displayed,
change the view via iDrive:
1.
If necessary, tilt the Controller to the side.
2. "Rear view camera"
The image from the rear-view camera is shown.
Operating requirements
▷ The tailgate is completely closed.
▷ Keep the detection range of the camera
clear. Projecting loads, carrier systems or
trailers can restrict the detection range of the
camera.
Seite 283
Driver Assistance Systems
CONTROLS
283
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
