tection that can be used to activate the driver
profile.
Countries in which ConnectedDrive is not avail‐
able: If PIN protection has not been set up or the
PIN is not known, the driver profile cannot be ac‐
tivated.
Countries in which ConnectedDrive is available: If
PIN protection has not been set up or the PIN is
not known, the driver profile can be activated
with the login details for the relevant Connected‐
Drive account.
1. "CAR"
2. "Driver profiles"
3. Tilt the Controller to the right.
As an alternative to steps 1 to 3, it is possible
to tap the profile picture in the upper status
bar.
4. "Driver recognition"
5. "using PIN"
Changing/cancelling recognition
If a different vehicle key or a different digital key
is assigned to a driver profile, the current assign‐
ment must be cancelled first.
1.
"CAR"
2. "Driver profiles"
3. Tilt the Controller to the right.
As an alternative to steps 1 to 3, it is possible
to tap the profile picture in the upper status
bar.
4. "Driver recognition"
5. Select the desired setting:
▷ "with vehicle key"
▷ "With Digital Key"
6. "Activate linkage"
If the vehicle and the vehicle key are handed over
for a service, for example, carry out the following
steps first:
▷ Set up PIN protection.
▷ Cancel recognition via the vehicle key.
▷ Switch to the guest profile.
This means the vehicle key that is handed over
can no longer be used to access the personal
driver profile.
Selecting a driver profile
The driver profile is selected automatically based
on the recognition of the key/remote control.
If the guest profile is active, the driver profile is
selected on the welcome screen or via iDrive. A
PIN may need to be entered.
1. "CAR"
2. "Driver profiles"
As an alternative to steps 1 and 2, it is possi‐
ble to tap the profile picture in the upper sta‐
tus bar.
3. Select a driver profile.
4. "OK"
The settings saved in the selected driver profile
are applied automatically.
Switching synchronisation with
the ConnectedDrive account
on/off
ConnectedDrive countries:
The settings saved in the driver profile are
synchronised with the personal ConnectedDrive
account. This makes it possible to use the per‐
sonal settings in other BMW vehicles with Con‐
nectedDrive access as well, provided that this
function is supported.
Synchronisation with the ConnectedDrive ac‐
count is enabled when a driver profile is created
or via iDrive:
1.
"CAR"
2. "Driver profiles"
3. Tilt the Controller to the right.
As an alternative to steps 1 to 3, it is possible
to tap the profile picture in the upper status
bar.
Seite 82
CONTROLS
Personal settings
82
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
