E85 Information/Communication
- 88 -
Accepting a call
The call ringer in the Bluetooth mobile phone sounds when a
mobile phone signal is received via the GSM aerial. At the same
time, a signal is sent via the Bluetooth interface in the mobile
phone to the Bluetooth aerial in the vehicle.
The Bluetooth aerial is connected to the Bluetooth module in the
charging and hands-free unit ULF. The ULF recognizes the
incoming call and mutes the radio. The speakers for outputting
the tone signal are enabled by the audio system and the tone
signal additionally sounds.
The following options are available for accepting the call:
- Press send/receive key on radio/operating unit
- Press send/receive key on base plate
- Press send/receive key on MFL (if installed)
- Press send/receive key on mobile phone
Conducting a call
If the call is accepted by pressing the send/receive key on the
radio or on the base plate, it will be conducted via the hands-
free microphone and vehicle speakers.
If a call is accepted by pressing the send/receive key on the
mobile phone, the reaction will depend on the type of handset.
In the majority of cases, however, the question appears:
"Do you wish to use the mobile phone?"
Refer to the operating instructions of the mobile phone for a
detailed description of the operating procedure.
To Next Page
Loading...
