Reverse R
Select only when the vehicle is stationary.
N is Neutral
The vehicle may be pushed or roll without power,
for instance in vehicle washes, refer to
page 103, in selector lever position N.
P Park
Engage only while the vehicle is stationary and
the brake is applied. The drive wheels are
blocked.
Selector lever position P is engaged automati‐
cally in the following situations:
▷ If the driver's safety belt is off, the driver's
door is open and neither brake nor accelera‐
tor pedal are depressed while drive-ready
state is switched on and selector lever posi‐
tion D or R is set.
▷ After switching off drive-ready state via the
Start/Stop button, if selector lever position D
or R is set.
▷ With standby state switched off.
Before exiting the vehicle, make sure that selec‐
tor lever position P is set. Otherwise, the vehicle
may begin to move. On uphill grades, also Set
parking brake, refer to page 107.
Engaging selector lever positions
General information
▷ Interlock: the selector lever position P can be
exited only with drive-ready state engaged.
▷ Shift lock: with the vehicle stationary, press
on the brake pedal before shifting out of P
or N; otherwise, the shift command will not be
executed.
▷ Shift lock: before shifting out of P, remove the
charging cable from the vehicle; otherwise,
the shift command will not be executed.
Engage D, N, R
Turn the selector lever in the desired direction.
The engaged selector lever position is displayed
on the selector lever.
Engaging P
Press button P.
Rolling or pushing the vehicle
General information
In some situations, the vehicle is to roll without
its own power for a short distance, for instance in
a vehicle wash, or be pushed.
Engaging selector lever position N
1.
Switch on drive-ready state while pressing on
the brake pedal.
2. If necessary, release the parking brake.
3. Depress the brake pedal.
4. Engage selector lever position N.
5. Switch off drive-ready state.
Seite 103
Driving
CONTROLS
103
Online Edition for Part no. 01402989267 - II/18
To Next Page
Loading...
