The selected temperature is shown on the dis‐
play of the automatic climate control.
The automatic climate control reaches this tem‐
perature as quickly as possible, if needed, by in‐
creasing the cooling or heating output, and then
keeps it constant.
Do not rapidly switch between different tempera‐
ture settings. Otherwise, the automatic climate
control will not have sufficient time to adjust the
set temperature.
To reduce the energy consumption, the cooling
or heating output is reduced or deactivated as
per ECO-PRO mode, refer to page 205.
Air conditioning
Concept
The air in the car's interior will be cooled and de‐
humidified and, depending on the temperature
setting, warmed again.
The car's interior can be cooled with the station‐
ary climate control or via the A/C button with
drive-ready state activated.
Switching on/off
Press button.
The LED is illuminated with air condi‐
tioning switched on.
Depending on the weather, the windshield and
side windows may fog up briefly when drive-
ready state is activated.
The air conditioning is switched on automatically
with the AUTO program.
When using the automatic climate control, con‐
densation water, refer to page 201, develops
and drains underneath the vehicle. This is nor‐
mal.
Maximum cooling
Concept
The system is set to the lowest temperature, op‐
timum air flow and recirculated-air mode.
General information
The function is available above an external tem‐
perature of approximately 32 ℉/0 ℃ or the drive-
ready state is available.
Switching on/off
Press button.
The LED is illuminated with the system
switched on.
Air flows out of the vents to the upper body re‐
gion. The vents need to be open for this.
If ECO PRO+, refer to page 205, is activated,
this function is deactivated.
The air flow can be adjusted with the air flow ac‐
tive.
AUTO program
Concept
Air flow, air distribution and temperature are con‐
trolled automatically.
Switching on/off
Press button.
The LED is illuminated with the AUTO
program switched on.
Depending on the selected temperature, the in‐
tensity of the AUTO program, and outside influ‐
ences, the air is directed to the windshield, side
windows, upper body, and into the floor area.
The air conditioning, refer to page 176, is
switched on automatically with the AUTO pro‐
gram.
At the same time, a condensation sensor con‐
trols the program so as to prevent window con‐
densation as much as possible.
To switch off the program: press the button
again or manually adjust the air distribution.
Seite 176
CONTROLS
Climate control
176
Online Edition for Part no. 01402989267 - II/18
To Next Page
Loading...
