BMW R 1100 RS User Manual

34.15
[RT/R] Removing and installing rear
brake disc (attached to rear wheel
drive)
•
Remove the brake caliper.
•
Remove rear wheel.
•
Heat the brake disc retaining screws (1) to
120 °C/remove.
L Note:
Mark installed position of brake disc, so that lateral
runout of sensor wheel is not changed.
•
Install in the reverse order of work.
•
Degrease the brake disc before installing.
e Caution:
[ABS] Check sensor gap and adjust with spacing
plates if necessary.
[ABS] If the brake disc and therefore the sensor
wheel are renewed, the disc’s lateral runout must be
determined/marked.
Sensor gap:.. 0.45...0.55 mm (0.0177...0.02165 in)
X Tightening torque:
Brake disc to rear wheel drive
(clean thread + Loctite 273).......................... 21 Nm
1
RT340162

BMW R 1100 RS Specifications

General

Displacement	1085 cc
Transmission	5-speed
Final Drive	Shaft drive
Engine Type	Air/oil-cooled flat twin (boxer)
Power	66 kW (90 hp) at 7, 250 rpm
Torque	95 Nm at 5500 rpm
Front Suspension	Telelever
Rear Suspension	Paralever
Front Brakes	Dual disc
Rear Brakes	Single disc
Fuel Capacity	22 liters
Seat Height	800 mm
Wheelbase	1471 mm