To Next Page

To Previous Page

Maintenance and care

High (main) beam

e Attention:

Switch off the ignition before

changing a bulb.

L Note:

Do not touch the glass of new

bulbs with the fingers.

Use a clean, dry cloth to hold

the bulbs when inserting them.

• Make sure the ground is level

and firm and lift the motor-

cycle onto its side stand

• Turn the handlebars to the left

Removing:

• Take off the left rubber

cover 3

• Detach plug housing 2 from

bulb connector

• Release spring clips 1 from

retainer A at left and right and

swing clips upwards

• Remove the H7 bulb

– High (main) beam:

H7 12 V 55 W

Changing bulbs

20sbkg7.book Seite 46 Mittwoch, 2. Juni 2004 8:58 08

Other manuals for BMW R 1100 S

Questions and Answers:

Need help?

Do you have a question about the BMW R 1100 S and is the answer not in the manual?

General

Displacement	1085 cc
Bore x Stroke	99 mm x 70.5 mm
Compression Ratio	10.3:1
Transmission	5-speed
Final Drive	Shaft drive
Fuel System	Electronic fuel injection
Rear Brakes	Single 276 mm disc, 2-piston caliper
Front Tyre	120/70 ZR 17
Rear Tyre	170/60 ZR 17
Wheelbase	1, 478 mm
Fuel Capacity	18 liters
Engine Type	Air/oil-cooled, 4-stroke, flat twin
Power	98 hp @ 7, 500 rpm
Front Suspension	Telelever
Rear Suspension	Paralever
Seat Height	810 mm
Front Brakes	Dual 305 mm discs, 4-piston calipers