BMW R 1150 RT Repair Manual

34.11
34 52 111 Removing and installing rear
Integral ABS sensor
•
Remove front and rear seats.
•
Remove right case, if necessary.
•
Remove small right side fairing panel.
•
Remove the cable ties securing the sensor ca-
ble.
•
Disconnect plug (1) of sensor cable.
•
Before removing/installing, clean the sensor
bore.
•
Remove sensor (2).
•
Installation is the reverse of the removal proce-
dure.
•
Coat O-rings with oil before installing.
e Attention:
Route the sensor cable correctly.
X Tightening torque:
Sensor ........................................ hand-tight, 4 Nm
1
2
R22340070

BMW R 1150 RT Specifications

General

Displacement	1130 cc
Transmission	5-speed
Final Drive	Shaft
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
ABS	Optional
Engine Type	Air/oil-cooled, four-stroke, Boxer twin
Power	95 hp at 7, 250 rpm
Torque	100 Nm at 5, 500 rpm
Dry Weight	259 kg
Front Suspension	Telelever
Rear Suspension	Paralever
Front Brakes	Dual disc
Rear Brakes	Single disc
Wheelbase	1485 mm (58.5 in)