Press button 1 again to switch
off the LED auxiliary headlights.
Daytime riding light
with daytime running light
OE
Manual daytime riding
light
Requirement
Automatic daytime riding lights
are switched off.
WARNING
Activation of daytime riding
light in the dark.
Poorer vision and oncoming
traffic dazzled.
Do not use the daytime run-
ning light when it is dark.
NOTICE
By comparison with the low-
beam headlight, the daytime
running light makes the vehicle
more visible to oncoming traffic.
This improves daytime visibility.
Start engine ( 91).
Repeatedly short-press but-
ton 2 until the SETUP menu
appears on the display.
Press and hold down button 2
to call up the SETUP menu.
Repeatedly short-press but-
ton 2 until Auto. DRL ap-
pears on the display.
Press button 3 to switch auto-
matic daytime riding light OFF.
Press button 1 to switch on
the daytime riding light.
The symbol appears on the
display.
The low-beam headlight, the
front side lights and the auxili-
ary headlights are switched off.
In the dark or in tunnels: Press
button 1 again to switch off the
daytime riding light and switch
on the low-beam headlight and
the front side lights. The aux-
iliary headlight is also switched
on again.
NOTICE
If you switch on the high-beam
headlight on while the daytime
running light is on, the daytime
riding light is switched off after
approx. 2 seconds and the high-
beam headlight, low-beam head-
light, front side lights and, if ap-
plicable, the auxiliary headlights
are switched on.
If the high beam headlight is
switched off again, the daytime
4
57
z
Operation
To Next Page
Loading...
Need help?
General
