then maintained in this posi-
tion until execution of the shift
is completed. No additional in-
crease in shifting force is nec-
essary during the gear shifting
process. After the gear change
is completed, the gear lever must
be fully released before the Gear
Shift Assistant Pro can execute a
new gear change. The load fac-
tor (throttle grip position) should
remain constant both prior to and
during execution of shifts using
the Gear Shift Assistant. Chang-
ing the position of the throttle
grip while the shift is in progress
can lead to cancelation of the
function and/or shifting errors.
No support is provided by the
Gear Shift Assistant during gear
changes made using the clutch.
Downshifts
Downshifts are assisted up to
the speed at which the engine
reaches maximum rpm in the
gear to be engaged. Over-
revving is thus prevented.
Maximum engine speed
max 9000 min
-1
Upshifts
The Gear Shift Assistant does
not provide added support
when the engine speed would
fall below idle in the new gear.
Idle speed
1150 min
-1
(Engine at operat-
ing temperature)
Hill Start Control
with Hill Start Control
OE
Hill Start Control relies on partial
ingetration of the ABS system
to prevent the motorcycle from
rolling back on hills, making it un-
ncessary for the rider to maintain
constant pressure on the brake
lever when starting on a slope.
When Hill Start Control is acti-
vated, pressure is generated in
the rear brake circuit to ensure
that the motorcycle remains sta-
tionary on a sloping surface. The
brake system's actual holding
pressure varies according to the
inclination angle of the slope.
BMW Motorrad Integral
ABS
Partially integral brake
Your motorcycle is equipped with
a partially integral brake configu-
ration. Both front and rear brakes
are applied simultaneously when
you pull the handbrake lever.
6
108
z
Technology in detail
ProCarManuals.com
To Next Page
Loading...
Need help?
General
