Motion sensor is deactivated.
Alarm
The alarm can be triggered by
the motion sensor
an attempt to use an unau-
thorized key to switch on the
ignition
disconnecting the DWA from
the motorcycle battery (DWA
battery takes over the power
supply – alarm sound only, haz-
ard warning lights do not flash)
If the DWA battery is discharged
all functions remain operational;
the only difference is that the
alarm cannot be set off if the
system is disconnected from the
motorcycle battery.
An alarm lasts for approximately
26 seconds. During the alarm,
an alarm tone sounds and the
turn indicators flash. The type
of alarm sound can be set by
an authorized BMW Motorrad
retailer.
You can cancel an alarm at any
time without deactivating the
alarm system by pressing but-
ton 2 on the remote key or radio-
operated key.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The alarm system indicator lamp
then signals the reason for the
alarm for one minute.
The meanings of the flash codes
are as follows:
1 flash: Motion sensor 1
2 flashes: Motion sensor 2
3 flashes: ignition switched on
with unauthorized key
4 flashes: DWA disconnected
from motorcycle battery
5 flashes: Motion sensor 3
Deactivation without
remote key or radio-
operated key
Emergency on/off switch (kill
switch) in normal operating po-
sition.
Switch on the ignition.
Turn indicators light up once.
Confirmation tone sounds once
(if programmed).
DWA is now switched off.
To deactivate the motion sen-
sor (for example if you are
about to transport the motorcy-
cle on a train and the swaying
movement of the moving train
4
83
z
Operation
ProCarManuals.com
To Next Page
Loading...
Need help?
General
