Do not touch parts of the igni-
tion system when the engine
is running.
Catalytic converter
If misfiring causes unburned
fuel to enter the catalytic con-
verter, there is a danger of
overheating and damage.
For this reason, observe the
following points:
Do not run the fuel tank dry
Do not run the engine with
the spark-plug cap removed
Stop the engine immediately
if it misfires
Use unleaded fuel only
Comply with all specified
maintenance intervals.
Unburned fuel will de-
stroy the catalytic con-
verter.
Note the points listed for
protection of the catalytic
converter.
Risk of fire
Temperatures at the exhaust
are high.
Flammable materials
(e.g. hay, leaves, grass,
clothing and luggage, etc.)
could ignite if allowed to
come into contact with the
hot exhaust pipe.
Make sure that no highly
flammable materials can
come in contact with the hot
exhaust system.
Cooling would be
inadequate if the
engine were allowed to
idle for a lengthy period
with the motorcycle at a
standstill: overheating would
result.In extreme cases, the
motorcycle could catch fire.
Do not allow the engine to
idle unnecessarily.After start-
ing, ride off immediately.
Tampering with the
control unit of the
electronic engine-
management system
Tampering with con-
trol unit of electronic
engine-management system
can damage the motorcycle
and cause accidents.
Do not tamper with the
control unit of the electronic
engine-management
system.
Tampering with con-
trol unit of electronic
engine-management system
can result in mechanical loads
that the motorcycle's com-
ponents are not designed to
withstand. Damage caused in
this way is not covered by the
warranty.
Do not tamper with the
control unit of the electronic
5
55
z
Riding
To Next Page
Loading...
Need help?
General
