delete the pairing information for some
other device.
▷ Audio connection is activated. Deactivate
audio connection.
▷ Is the mobile phone in power-save mode or
is the battery low? Charge the mobile phone
using the snap-in adapter or the charging
cable.
▷ If appropriate, only one mobile phone can be
connected to the vehicle, depending on the
mobile phone. De-register the mobile phone
from the vehicle and only register and con‐
nect one mobile phone.
The mobile phone is no longer responding.
▷ Switch the mobile phone off and on again.
▷ Too high or low ambient temperatures? Do
not subject the mobile phone to extreme
ambient conditions.
Telephone functions not possible.
▷ Mobile phone registered as additional tele‐
phone and additional telephone function
disabled? Enable function.
▷ Outgoing call not possible? Connect mobile
phone as telephone.
No phone book entries, not all entries or incom‐
plete entries are displayed.
▷ Transfer of the phone book entries has not
completed.
▷ Under certain circumstances only the phone
book entries saved in the mobile phone or
on the SIM card are transferred.
▷ It might be that phone book entries with spe‐
cial characters cannot be displayed.
▷ Number of phone book entries to be stored
is too high.
▷ Data volume of the contact too large, e.g.
due to stored information such as notes?
Reduce data volume of the contact.
▷ Mobile phone connected as audio source?
Mobile phone must be connected as tele‐
phone.
▷ Mobile phone connected as audio source or
additional telephone? Mobile phone must
be connected as telephone.
Quality of the phone connection is poor.
▷ Bluetooth signal strength can be adjusted
on mobile phone, depends on the model.
▷ Place the mobile phone in the snap-in
adapter or close to the centre console.
▷ Adjust the volume of the microphone and
speaker separately.
If all the points on the list have been reviewed
and the desired function cannot be run, contact
Hotline or Service Centre.
Controls
Adjusting the volume
Turn the knob until the desired volume is
reached. The setting is saved for the remote
control currently in use.
The vehicle adjusts the volume of the micro‐
phone on the telephone and the volume of the
other party automatically. Depending on the
mobile phone, it may be necessary to adapt the
volumes. Settings are possible only during a call
and must be adjusted separately for each tele‐
phone. The settings are deleted as soon as the
telephone is de-registered.
1.
"Settings"
2. "Tone"
3. "Volume settings"
4. Select desired setting: "Microphone" or
"Loudspeak."
5. Adjusting: turn the controller.
6. Saving: press the controller.
Incoming call
Receiving a call
If the number of the caller is saved in the tele‐
phone book and is transferred from the network,
Seite 212
Communication Telephone
212
Online Edition for Part no. 01 40 2 900 867 - 03 12 490
To Next Page
Loading...
Need help?
General
