Set interval time or sensitivity of the
rain sensor
Turn the knurled wheel.
Cleaning the window glass, headlights
Pull the lever.
Fluid from the washer fluid reservoir is sprayed
onto the windscreen and the wipers are oper‐
ated briefly.
When the vehicle's lights are switched on, the
headlights are also cleaned simultaneously at
practical intervals.
Do not use the washer system in the event
of frost
Only operate the washer systems and cleaning
equipment if you are certain that the fluid will not
freeze on the windscreen and interfere with the
view ahead. Therefore, use anti-freeze.
Do not use the washer systems if the fluid res‐
ervoir is empty, or the washer pump will be dam‐
aged.◀
Windscreen washer jets
Both windscreen washer jets are automatically
heated when the ignition is switched on.
Switching on rear window wiper
Push the lever forwards to activate intermittent
operation. Engaging reverse gear activates con‐
tinuous operation.
To clean the rear window push the lever further
forward.
Fold-out position of the wipers
This is important, for example for replacing the
wiper blades or folding them out in the event of
frost.
1.
Switch the ignition off.
2. If there is a risk of frost, make sure that the
wiper blades are not frozen.
3. Press the wiper lever upwards beyond the
resistance point and hold it there for approx‐
imately three seconds until the wipers come
to a standstill in a nearly vertical position.
After folding the wipers in, the wiper system
must be reactivated.
Folding the wipers onto the windscreen
Before switching on the ignition, fold the
wipers onto the windscreen, as otherwise dam‐
age can occur when the wipers are switched
on.◀
1.
Switch on ignition.
2. Press the wiper lever downwards. The wip‐
ers move to the rest position and are opera‐
tional once again.
Seite 67
Driving Controls
67
Online Edition for Part no. 01 40 2 900 867 - 03 12 490
To Next Page
Loading...
Need help?
General
