to change from selector lever position P to an-
other selector lever position.
Engaging selector lever position D/S,
N, R
With the driver's seat belt fastened, press on
the brake pedal and pull or push the selector
lever in the required direction. The selector
lever automatically returns to the center posi-
tion when released.
In selector lever position R, the selector lever
locks.
Engaging selector lever position P
Press button P.
Rolling or pushing the vehicle
General information
In some situations, the vehicle is supposed to
roll without its own power for a short distance,
for instance in a car wash or to be pushed.
Engaging selector lever position N
NOTICE
Selector lever position P is automatically en-
gaged when standby state is switched off.
The wheels are blocked. There is a risk
of damage to property. Do not switch off
standby if the vehicle is meant to coast, e.g.,
in a car wash.
1. Switch on drive-ready state while pressing
on the brake pedal.
2. If necessary, release the parking brake.
3. If necessary, deactivate Automatic Hold.
Automatic Hold, refer to page 131.
4. Depress the brake pedal.
5. Engage selector lever position N.
6. Switch off drive-ready state.
In this way, standby state remains switched
on, and a Check Control message is dis-
played.
The vehicle can roll.
Selector lever position P is engaged automati-
cally after approximately 35 minutes.
If the system is not operational, you may not
be able to change the selector lever position.
Electronically unlock the transmission lock, if
needed.
Additional information:
Electronic unlocking of the transmission lock,
refer to page 127.
Kickdown
Kickdown is used to achieve maximum drive
power in Drive mode.
Step on the accelerator pedal beyond the re-
sistance point at the full throttle position.
Seite 123
Driving
CONTROLS
123
Online Edition for Part no. 01405A8A608 - VI/23
To Next Page
