Notes
Tire damage caused by external influen‐
ces
Sudden tire damage caused by external influ‐
ences cannot be indicated in advance.◀
To operate the system, also note the additional
information and instructions contained under
Tire inflation pressure, refer to page 156.
Functional requirement
The system must have been reset while the in‐
flation pressure was correct; otherwise, reliable
signaling of pressure loss is not ensured.
Reset the system after adjusting the tire infla‐
tion pressure and after changing a tire or
wheel.
Always use wheels with TPM electronics to
ensure that the system will operate properly.
Resetting the system
Reset the system after adjusting the tire infla‐
tion pressure and every time a tire or wheel is
changed.
Operating principle, refer to page 65.
1.
Start the engine, but do not start driving.
2. Lightly press button 1 in the turn indicator
lever up or down repeatedly until the corre‐
sponding symbol and "RESET" appear.
3. Press button 2 to confirm your choice of
the Tire Pressure Monitor.
The following display appears:
4. Press button 2 for approx. 5 seconds until
the small warning light lights up yellow and
the following display appears:
5. Drive away.
After a short trip at over 30 km/h, the set
tire inflation pressures are adopted as tar‐
get values. The system reset is completed
as you drive, and can be interrupted at any
time. When driving resumes, the reset is
continued automatically. The indicator
lamp goes out after the system reset is
completed.
Low tire pressure message
The warning lights come on in yellow
and red. In addition, a signal sounds.
▷ There is a flat tire or a major loss
in tire inflation pressure.
▷ The system was not reset. The system
therefore issues warnings in case of devia‐
Seite 80
Controls Safety
80
Online Edition for Part no. 01 40 2 957 378 - X/14
To Next Page
Loading...
Need help?
General
