4. INSTALLATION.
4.1 CHOOSING A LOCATION FOR YOUR B16C
The B16C controller should be mounted on an internal wall approximately 1.5 meters from floor
level and should be in a position away from draughts, direct heat and sunlight.
4.2 INSTALLING THE B16C
The thermostat requires a one
gang back box having a
minimum depth of 35mm.
1) Remove the front screen
from the thermostat by
gently using a screwdriver
underneath the front lip to
release the two plastic clips.
Gently pull the screen towards you releasing the internal
plug which allows the two parts to be separated.
2) Now remove the plastic centre housing from the back plate
by gently lifting in the direction shown in the picture. Once
lifted gently pull towards you exposing the black metal back
plate.
To Next Page
