3) Wire the thermostat as per picture 1
making sure all the terminals are
done up tightly. An under floor
sensor must be used (supplied) and
this MUST only be wired to terminals
5 and 6. Polarity of the sensor does
not matter. Do NOT exceed total
load of 16A. For loads greater than
this, use a contactor with the
thermostat controlling the coil of the
contactor.
4) Once all the connections have been
made, make sure the arrow on the
back plate faces upwards and secure
to the back box using two screws. See
picture 2 to the right.
5) Slide on the centre housing until it
clips into position. See picture 3
above.
6) Finally push the plug into the socket
on the front screen and clip onto the
centre housing. Note:- The plug only
fits one way around so don’t force it.
To Next Page
