7.2.4
Setting the Output Reference
7.2.5 Rearming the System
7.2.6 Setting the Shot Counter Parameters
7.3 CHANNEL MENUS
7.3.1 Enabling Channel Output
7.3.2 Channel Menu in Burst Mode
7.3.3 Channel Menu in Duty Cycle Mode
7.3.4 Channel Page Sub-Menus
7.3.5 Sync Menu
7.3.6 Output Menu
7.3.7 Channel Multiplexer
7.4 OTHER SYSTEM MENUS
7.4.1 Gate or Trigger Input Menu
7.4.2 Saving and Loading Configurations
7.4.3 Communication Configurations
7.4.4 Configuration Menu
7.4.5 Information Menus
8 REMOTE COMMUNICATION
8.1 RS-232 INTERFACE
8.2 USB INTERFACE
8.3 GPIB INTERFACE
8.4 ETHERNET INTERFACE
8.4.1 IP Address and Raw TCP/IP Connection
8.4.2 Determining IP Address
8.4.3 Setting the 577 to Raw TCP Protocol
8.5 PROGRAMMING COMMAND TYPES AND FORMAT
8.5.1 Line Termination
8.5.2 IEEE 488.2 Common Command Format
8.5.3 SCPI Command Format
8.5.4 SCPI Keyword Separator
8.5.5 SCPI Optional Keywords
8.5.6 SCPI Specific and Implied Channel
8.5.7 SCPI Parameter Types
8.5.8 Error Codes
8.6 577 COMMANDS (SCPI COMMAND SUMMARY)
9 OPTION DT15 (DUAL TRIGGER)
9.1 ENABLING SYSTEM TRIGGER
10 OPTION AT35 (35V OUTPUT / FAST RISE)
11 OPTION TZ50 (TTL IMPEDANCE MATCHING)
12 OPTION AT45 (45V OUTPUT)
12.1 AT45 PROTECTION ERROR MESSAGES
12.1.1 Module Errors
12.1.2 System Limit Error
12.2 VOLTAGE CHANGE TIMING
12.3 AT45 SCPI COMMAND EXTENSION SUMMARY
13 SAFETY MARKING SYMBOLS
14 MODEL 577 SPECIFICATIONS
Berkeley Nucleonics Corporation
info@berkeleynucleonics.com | www.berkeleynucleonics.com
2955 Kerner Blvd, San Rafael, CA 94901 | 800-234-7858
To Next Page
Loading...
