Need help?Do you have a question about the BNC 577 and is the answer not in the manual?
Contact information for technical assistance.
Details the two-year limited warranty for defects.
How to select system modes like Continuous, Single Shot, Burst, Duty Cycle.
How to set the internal/external clock source and rate.
Overview of menus for configuring individual channels.
Setting up Gate/Trigger input functionality and levels.
Setting up communication parameters like Baud Rate and Echo.
Configuration and pin-out for the RS-232 serial port.
How to set up and use the USB interface for communication.
Details SCPI command structure and syntax.
Commands for global pulse settings.
Commands for setting global trigger modes.
Commands for setting gate modes and logic.
Commands for channel-specific pulse settings.
Commands for output mode and amplitude.
Specifications for the AT35 module.
Specifications for the TZ50 TTL Impedance Matching module.
Specifications for the AT45 module.
General| Category | Pulse Generator |
|---|---|
| Output Impedance | 50 Ω |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Trigger Modes | Internal, External, Single |
| Trigger Input | TTL |
| Trigger Output | TTL |
To Next Page
