BNC 577 - AT35 Specifications

Model 577 Operating Manual 29
Output Resolution
10 mV
Current
200 mA typical, 400 mA (short pulses)
Rise Time
15 ns typ @ 20V (high imp)
25 ns typ @ 10V (50 ohms)
(10% - 90%)
Slew Rate
>0.1 V/ns
Overshoot
<100 mV + 10% of pulse amplitude
Trigger/Gate Dual Input Module (Standard)
Trigger Input:
Function
Generate individual pulses, start a burst or continuous stream
Rate
DC to 1/ (200 ns + longest active pulse). Maximum of 20 MHz
Slope
Rising or Falling
Threshold
0.2 to 15 VDC
Maximum Input
30 V Peak
Resolution
10 mV
Trigger Accuracy
±3% of Threshold Voltage
Impedance
5.3 Kohm + 40 pF
Rate
DC to 20 MHz
Trigger Jitter
< 800 ps RMS
Insertion Delay
< 100 ns
Minimum Pulse Width
≥ 20 ns
Pulse Inhibit Delay
< 150 ns RMS
Output Inhibit Delay
< 100 ns RMS
Gate Input:
Mode
Pulse inhibit or output inhibit
Polarity
Active high/active low
Trigger Jitter (Gate as Trigger Input)
< 800 ps RMS
Optical Outputs
Wavelength
820 nm or 1300nm
Maximum Signal Rate
5 MBd
Maximum Link Dist.
1.5 Km
Connector Type
ST
Optical Inputs
Wavelength
820 nm or 1300 nm
Maximum Signal Rate
5 MBd
Maximum Link Dist.
1.5 km
Connector Type
ST
Insertion Delay
<300 ns
Jitter
<1.4 ns RMS
AT35 Specifications
Through a 50Ω load at 200 Hz
Output
5 V – 35 V
Setpoint Resolution
10 mV
Rise Time
< 30 ns
Accuracy
500 mV
Max. Frequency
(Internal & External)
4000 Hz