Model 577 Operating Manual 26
Command to change the units system settings.
Command to turn on or off the systems' beeper.
Command to change the units' beeper volume.
4800 / 9600 / 19200 /
38400 / 57600 /
115200
Command to change the baud rate for the USB
interface.
Command to enable/disable the echo function on the
USB interface. The Echo function will cause the unit to
repeat the command received to the PC.
4800 / 9600 / 19200 /
38400 / 57600 /
115200
Command to change the baud rate for the RS - 232
interface.
Command to enable/disable the echo function on the
RS - 232 interface. The Echo function will cause the
unit to repeat the command received to the PC.
Sets the GPIB Address if the Comm option is installed.
When the unit is powered up, if this command is
enabled, the unit will start pulsing automatically.
Command to lock out the keypad.
The default value is 1, which means the unit is not case
sensitive. 0 means the commands sent to the unit must
be capitalized.
*Note: To change this parameter the unit must be
power cycled before the command will take effect.
Query only. Returns the Serial Number the 577
Query only. Returns the current Firmware and
Bootloader versions installed on the 577 Main
Processor
Query only. Returns only the current Bootloader
version installed on the 577 Main Processor
Query only. Returns the current Firmware version
installed on the 577 Front Panel Processor
Query only. Returns the current FPGA code version
installed on the 577
Query only. Returns the serial number of the unit.
Query only. Returns firmware and FPGA identification
numbers. Is used to identify Non-Standard FW and
FPGA codes that may have been created for customer
testing.
To Next Page
Loading...
